Mineral Preparation Using Rod Mill for Mineral Galena Characterization

Authors

  • Riria Zendy Mirahati Metallurgical Engineering Study Program – Mining Engineering Department, Faculty of mineral engineering, UPN “Veteran” Yogyakarta
  • Yasmina Amalia Metallurgical Engineering Study Program – Mining Engineering Department, Faculty of mineral engineering, UPN “Veteran” Yogyakarta
  • Mochamad Juliyanto Metallurgical Engineering Study Program – Mining Engineering Department, Faculty of mineral engineering, UPN “Veteran” Yogyakarta
  • Lintang Larasati Adi Putri Metallurgical Engineering Study Program – Mining Engineering Department, Faculty of mineral engineering, UPN “Veteran” Yogyakarta

DOI:

https://doi.org/10.31098/cset.v1i1.396

Abstract

Galena mineral preparation was carried out for mineral characterization. The mineral characterization carried out included XRD (X-Ray Diffraction), XRF (X-Ray Fluorescence), SEM-EDS (Scanning Electron Microscope-Energy Dispersive X-Ray). The preparation of galena minerals begins with the process of reducing the grain size including crushing and grinding. The results of crushing and grinding are then separated based on grain size using a sieve or siever to get a grain size of -200 mesh. The grinding process using a rod mill needs to be timed, so that the results are not too fine which is causing the recovery in the mineral concentration process to be low.

Downloads

Published

2022-11-15

How to Cite

Mirahati, R. Z. ., Amalia, Y. ., Juliyanto, M. ., & Putri, L. L. A. . (2022). Mineral Preparation Using Rod Mill for Mineral Galena Characterization. RSF Conference Series: Engineering and Technology, 1(1), 355–362. https://doi.org/10.31098/cset.v1i1.396

Issue

Vol. 1 No. 1 (2021): LPPM UPN "Veteran" Yogyakarta Conference Series 2021 - Engineering and Science Series

Section

Articles